Frequently Asked Questions


In this section, we’ll try and answer some of the more common questions you might have about
power washers and issues relating to the care and operation of power washers.


» What detergents can be used with a pressure washer?
Any detergent made for power washers can be used with the detergent injector that comes with many pressure washers. Remember, however, that when a detergent is injected into a pressure washer spray it is automatically diluted at a ratio of about 15-to-1.
^Top


» How does the detergent injector work?
Detergent never passes through the pump. Instead it is injected into the spray before it comes out of the nozzle. An injector works so that when the water pressure is lowered it automatically suctions the detergent from the jug or container. When you start up the pressure washer it will begin suctioning detergent from the jug or container and mix it with the low-pressure spray.
^Top


» Why can't detergent be used in high-pressure mode?
Because it would require the detergent to flow through the pump. Many detergents will damage the seals and packing of the pump causing it to leak or breakdown sooner.
^Top


» Can I siphon water from a lake or holding tank to operate the pressure washer?
Yes, provided the water passes through some type of screen or filter to at least 20 micron in size in order to prevent debris from damaging the pump. Make sure you have a filter in place before using a non-standard water supply.
^Top


» What are the engine oil specifications?
All specifications and troubleshooting details on the engine are found in the engine owner's manual that comes with each Workaholic pressure washer.
^Top


» What causes a pulsation in the pump?
Occasionally a spec of debris stuck in the nozzle will create a pulsating sensation or even an air pocket in the hose. Remove the nozzle and flush it with water or air. To remove an air pocket simply pull the trigger gun and let the water flow for a while and it will clear itself quickly.
^Top


» What is the warranty on my BullDogPRO™ power washer?
Refer to the owner's manual for warranty specifics, but generally speaking the chassis and frame have a 3-year limited warranty, the engine a 2-year warranty, and the pump a 5-year warranty on the oil end.
^Top


» Can hoses be added to extend the working distance?

Yes, extension hoses are available. However, a rule of thumb is that for every foot of hose coming out of the pressure washer the pressure drops 1 PSI (pound per square inch) so a 100-foot hose means the pressure will be 100 PSI less than what it is coming out of the pressure washer.
^Top


» Can I run hot water through my pressure washer pump?
No. Hot water higher than 140°F can potentially damage the pump. We have a full line of Workaholic hot water power washer to solve your hot water cleaning needs.
^Top


» How do I attach a nozzle to the wand?
Pull back on the quick-coupler collar, insert nozzle, release collar.
^Top


» How far should I stand from what I am cleaning?
Because pressure washers can damage some surfaces it is recommended that you stand 4 to 5 feet away from the surface at first and then slowly move closer to see what the impact of the spray is on the surface. Always test on an inconspicuous location.
^Top

 
2003 Cleaning System Specialists All Rights Reserved