| (Electric & Engine) |
When you need higher temperatures for faster degreasing, coatings removal, or for sanitizing... up to 250oF to 2000psi, or up to 330oF at 500psi... Several standard versions are available to 330oF. Call for details.
|
|
| (electric & engine) |
When you need higher temperatures for faster degreasing or for sanitizing. Feed the pump with up to 160oF. Many versions are available. Call for details.
|
|
|
(electric & engine)
|
Multiple users will easily increase productivity on time critical cleaning, Split the volume of your system with matched spray nozzles that will give you full pressure, with half the volume. Or, balance the combination you want, at a reduced pressure.
|
|
|
Variable Pressure Control |
 |
 |
 |
|
(electric & engine)
|
The "variable pressure wand" option gives you the ability to perform a much wider range of cleaning jobs with the same machine. By attaching this ingenious tool to your wand assembly, you gain much greater control over water pressure. You may need to keep water from penetrating worn rubber seals or to clean without blasting water through doorframes. The increased flexibility also allows you to attach a variety of tools that will quickly clean carpets, upholstery, awnings, or wood, then a minute later, blast rust from steel... Versatility Rocks!
|
|
|
(electric & engine)
|
Protect your investment ! As you probably know, running a pressure washer dry, even for a few moments, can cause severe damage to the pump. This disaster is easily avoided by installing the low-water shutdown option. Depending on the configuration you choose, either a fluid level switch is installed in the water tank, or a low-pressure switch is connected in-line from the fresh water supply. This device is connected so that any shortage in water supply instantly stops the machine thus preventing costly damage. You need this for longest-term-lowest-cost. |
|
|
(electric & engine)
|
If the operator leaves a pressure washer running unattended with the trigger gun not ejecting water, the water seals can heat up very quickly, doing damage to delicate pump and unloader seals. Our high-volume bypass system adds abuseability, but there's no replacement for ultimate control... A temperature limit switch installed in the bypass circuit of the pump prevents an overheat from ever occurring. By operating as a kill switch for total shutdown of the system, damage is averted if water temperatures become critical. Bypass overheat is one of the most common causes of system damage we see on other commercial pressure washers. |
|
|
|
|
|
|
Control Options